Apply a bead of plumber's putty to bottom edge of toilet base. Put on the toilet seat cover and clean up. Reconnect the supply tube to the new tank. Tilt the bowl forward and rock it from side-to-side. Shut off the water to the toilet. Disconnect the water supply tube. Next, detach the bowl from the floor. Place a new wax ring over the drain horn. Flush the toilet several times  PERT/PEX Pipes Manufacturers  to remove water from the bowl and tank. Tighten the nuts on the bolts while you're seated.

Lift the bowl FITTING FOR PEX-AL-PEX PIPES Manufacturers from the floor. Shifting can crack the wax seal and allow water to seep out from underneath. If this doesn't stop leakage, you may need to replace the wax ring. Make sure the toilet is level.If water is leaking from around the base of your toilet, check to see if it may have shifted. Test the toilet by flushing a few times. To fix this problem, sit on the toilet and twist it back into position.

Press the bowl down to the floor to compress the seal the best method is to sit on the toilet and rock back and forth.Turn the bowl back over and position it so the bolts fit through the holes. Twist the bowl a bit to make sure it is in the right place. Then soak up any remaining water with a mop or sponge.

Pry off the old wax seal that is around the pipe on the floor with a putty knife. Open the shut-off valve and let the tank fill with water. If you don't have an angle stop shut-off valve by your toilet, you need to shut off the water at your home's main shut-off valve. Unscrew the nuts using a wrench. There is less spillage if the bowl is tilted forward..Put the new wax or rubber seal around the hole. Be sure not to over-tighten the bolts or you can crack the porcelain.